Clearlight CE-2 Assembly Instructions Manual

Clearlight CE-2 Assembly Instructions Manual

Clearlight infrared sauna

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CE-2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Clearlight CE-2

  • Page 4 Assembly Instructions Clearlight Infrared Sauna: CE-2 Pa rt Li s t....................4 Pre-Assembly Instructions ................5...
  • Page 5 Parts List 1) Roof Panel 2) Front Panel 3) Back Wall 4) Right Side Wall Panel 5) Left Side Wall Panel 6) Bench 7) Under Bench Support 8) Floor Panel 9) Radio Remote Control 10) Keypad Remote Control 11) Magazine Rack 12) Towel Rack...
  • Page 6 READ BEFORE INSTALLATION: • Panels may be heavy. Be careful to avoid injury when installing. • Two adults are required for the installation of your sauna • There is a “+” button or a “–” button at the side of each panel. The panels will be installed by corresponding one “+”...
  • Page 7 Assembly Instructions 1) Place the floor in the desired location on a level surface (Note: The floor panel must be level before installing the wall and roof panels. If the surface is not level you may need to shim the bottom panel to make it level.) 2) Place back wall in the slot of floor.
  • Page 8 5) Installing the Under Bench Support and Bench: • Slide the Under Bench Support Panel down the wooden supports with the heater facing out. • Make sure the two side slots of the Bench Support Panel slide completely into the corresponding grooves of the wooden supports .
  • Page 9 9) Remove the screws used to lock the AM/FM/CD player before using. 10) Congratulation! You have finished the installation of your new Clearlight Infrared Sauna.
  • Page 10 CONTROL PANEL INSTRUCTION 1) Press “POWER”to turn your sauna on or off. 2) “TIME”refers to the amount of time for your sauna session. Once your sauna is powered on, the default session time of 45 minutes will be displayed. Press “ UP Arrow or “DOWN Arrow”...
  • Page 11 OPERATING INSTRUCTIONS FOR COLOR LIGHT THERAPY SYSTEM 1. To activate the color light therapy system press the “Color Light” button on the sauna control panel. Upon turning the system on, the color light system will go into an automatically cycling mode, changing color every 8 seconds: 2.
  • Page 18 □ □ □ □ AC240V Power Supply Power Consumption 1,750W □ □ □ □ Nordic Spruce □ □ □ □ Canadian Red Cedar Wooden Material Manufacture Clearlight Infrared Saunas / Sauna Works Address 2184 Sutter St. #282 San Francisco, CA 94115...

Table of Contents