Attaching The Bezel - F5 ARX-2000 Hardware Installation Manual

Chapter 2
Unpacking and Installing the Switch

Attaching the Bezel

2 - 6
2. Attach a serial console cable to the serial console port (identified in
the following figure).
Figure 2.2 ARX-2000 Serial Console Port
3. From the front of the switch, identify the power button (identified in
Figure 2.3).
The power button powers up the switch or places the switch in sleep
mode. To place the switch in sleep mode, press and hold the power
button for 5 seconds. To fully remove power from the system, you
must unplug all AC power cords from wall outlets. To locate the
power button, see the following figure.
Figure 2.3 ARX-2000 Power Button
4. Attach the front bezel. For details, see Attaching the Bezel, on page
2-6.
The front bezel and the ear assemblies hold the ARX-2000 in the rack. The
following figure shows the appearance of the front bezel when attached.
Figure 2.4 ARX-2000 Front Bezel