Wan Service - TP-Link TD-W8960N User Manual


Note:
Only one ETH is allowed to configure as the layer 2 WAN Interface.
4.3.2

WAN Service

Go to Advanced Setup
describes the WAN port settings and the relevant manipulation to each interface. After you add a
new Layer2 Interface, please follow the instructions below to complete the further configuration of
WAN Interface. There are five different configurations for the connection types, which are PPPoE,
IPoE, Bridge, PPPoA, and IPoA. You can select the corresponding types according to your needs.

Note:
Bridge mode is not available under Wireless Router Mode.

Note:
The following section adopts different VPI, VCI to introduce further configuration for the different
connection types, if you need to change the configuration of ATM PVC (VPI/VCI), go to the previous
section (4.3.1 Layer2 Interface) to configure them again.
4.3.2.1 ATM-EoA-PPPoE
If your ISP provides a
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface
2. Click Add and you will enter the next screen as shown below. Click Next.
3. Select the WAN service
can create a service name for the
→ WAN Service, and you will see the WAN Port Information Table, which
PPPoE connection and you need to use an ATM Interface, follow the steps
(4.3.1.1 ATM
type. If your ISP provides a PPPoE connection, select PPPoE. You
Service Description
Interface).
or leave it as default. Then click Next.
16
TD-W8960N User Guide