Time Search 41 - Philips DVD741VR Owner's Manual

H9231CD(EN).QX3 02.9.5 7:13 PM
VCR
Follow the steps below to program the DVD/VCR to search for-
ward or backward on a tape a specific length of time.There must
be a tape in the DVD/VCR.
G
Before you begin, place the DVD/VCR in VCR mode. Press
OUTPUT SELECT so the green VIDEO light appears on the
front of the DVD/VCR. Press VCR/TV so the green VCR/TV
light appears on the front of the DVD/VCR.
1
Press VCR, then press SEARCH MODE/TIME
SEARCH.
TIME SEARCH
0:00
ENTER SEARCH TIME
2
Within 10 seconds, use the Number buttons to
enter the desired length of time you want to skip
forward or backward. For example, for 1 hour, 25 min-
utes, press Number buttons 1, 2, 5. Or, for five minutes,
press Number buttons 0, 0, 5.
3
Within 10 seconds, press FF g (B) or REW h
(s). The DVD/VCR will skip over the specified length of
time, then begin playback.
Page 41

Time Search 41

POWER
MARKER
SETUP AUDIO SUBTITLE ANGLE
REC/OTR REPEAT REPEAT
A-B
CHANNEL/SKIP
CLEAR
TITLE MODE RETURN
OUTPUT SELECT
DVD VCR
DISC
OK
MENU
STOP PLAY
REW FF
3
PAUSE
TIMER SET
1 2 3
VCR/TV
2 4
5 6
MEMORY
7 8 9
SPEED
+ 10
0
SEARCH MODE DISPLAY ZOOM SLOW
TIME SEARCH STATUS/EXIT
Helpful Hints
• If you want to search for more than
59 minutes, you must enter the
length of time in hours and min-
utes. For example, to search forward
70 minutes, press 1,1,0 at step 2.
• You cannot do a Time Search while
recording.
• To remove the Time Search display,
press SEARCH MODE/TIME
SEARCH again.
• To cancel a Time Search that is in
progress, press STOP C (p).
• If the end of the tape is reached
during a Time Search, the Time
Search will be cancelled.The
DVD/VCR may rewind the tape.
Details are on page 43.
1