Philips DVD741VR Owner's Manual page 10

H9231CD(EN).QX3 02.9.5 7:13 PM
10 Hookups (cont'd)
DVD/VCR to Cable Box/DBS (Satellite Receiver) and TV
This connection will let you use the features of both the VCR and the DVD Player.
1
Cable
Signal
Connections
1
Connect a Cable signal to the DVD/VCR's ANT -IN (Antenna In) Jack.
2
Use an RF coaxial cable (as the one supplied) to connect the ANT -
OUT (Antenna Out) Jack on the DVD/VCR to the IN Jack on the
Cable Box/DBS.
3
Use a second RF coaxial cable to connect the OUT Jack on the
Cable Box/DBS to the ANTENNA IN Jack on the TV.
Remember...
There are two ways to connect your Cable Box/DBS to the DVD/VCR.With the con-
nection on this page:
G
You may watch one channel while recording another. Follow these steps:
1) Put the Cable Box/DBS on the same channel as the DVD/VCR's CH3/CH4
switch. Set the TV to the Cable Box/DBS output channel (03 or 04).
2) Press OUTPUT SELECT to put the DVD/VCR in VCR mode.The green VIDEO
light will appear on the front of the DVD/VCR.Then, press the VCR button, then
press VCR/TV to choose VCR position.The green VCR/TV light will appear on the
front of the DVD/VCR
3) Press CHANNEL/SKIP j/i (p/o) to select the channel you want to
record at the DVD/VCR. Start the recording.
4) Press the VCR/TV button once to put the DVD/VCR in TV position.The VCR/TV
light will go off.
5) Select the channel you want to watch at the Cable Box/DBS.
G
When you play a tape or Disc, make sure the Cable Box/DBS is set to the same
channel as the CH3/CH4 switch on the DVD/VCR. Set the TV to the Cable
Box/DBS output channel (03 or 04).
Page 10
Using only basic RF coaxial cables
DVD/VCR
2
ANT-IN
IN
L
AUDIO
ANT-OUT
R
CH3 CH4
VIDEO
RF coaxial
cable
Cable Box/DBS
DVD/VCR
COMPONENT
OUT
VIDEO OUT
DVD/VCR
Y
AUDIO OUT
DIGITAL AUDIO OUT
S-VIDEO
PCM / BITSTREAM
L Cr OUT
IN
COAXIAL OPTICAL
OU T
Cb
R
RF coaxial
cable
7 5
A N T
/
C A B
L E
3
TV's ANTENNA
IN Jack