Lexus RX450h Owners Book page 449

■
Programming a Rolling Code system (for U.S.A. owners)
If your device is Rolling Code equipped, follow the steps under the
heading "Programming the HomeLink
steps listed below.
Locate the training button on the ceiling mounted garage door
STEP 1
opener motor. The exact location and color of the button may
vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener
for the location of the training button.
Press the training button.
STEP 2
Following this step, you have 30 seconds in which to initiate step 3
below.
Press and hold the vehicle' s programmed HomeLink
STEP 3
2 seconds and release it. Repeat this step once again. The garage
door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and release the button a third time. This third
press and release will complete the programming process by opening
the garage door.
The ceiling mounted garage door opener motor should now recognize
the HomeLink
Repeat the steps above to program another rolling code system
STEP 4
for any of the remaining HomeLink
■ Programming an entry gate (for U.S.A. owners)/Programming all
devices in the Canadian market
Place your transmitter 1 to 3 in. (25 to 75 mm) away from the sur-
STEP 1
face of the HomeLink
Keep the HomeLink
Press and hold the selected HomeLink
STEP 2
Repeatedly press and release (cycle) the device' s remote control
STEP 3
button for two seconds each until step 4 is completed.
When the indicator light on the HomeLink
STEP 4
ceiver starts to flash rapidly, release the buttons.

signal and operate the garage door.

.

indicator light in view while programming.
3-7. Other interior features

" before proceeding with the

buttons.

button.

compatible trans-
3

button for
449