Table of Contents
Advertisement
GENERAL INSTALLATION INFORMATION
The unit is shipped fully assembled and ready to plug into a standard outlet specified for its voltage
and amp draw. If improper electrical supply can be determined through troubleshooting, contact
a qualified electrician prior to using the unit. Removal or replacement of the power cord or plug will
void the warranty. Should you require assistance, contact your local authorized service agent for any
service or required maintenance.
Allow enough space around the unit for adequate ventilation and make certain the cooling fan
is not blocked. It is required that you leave at least a four [4] inches (102 mm) gap on each side.
Additional space from extremely hot devices is recommended as this unit's intake air temperature
cannot exceed 104° F (40° C). Doing so will result in damage to the unit. Make certain this unit is not
located near other appliances which may produce grease vapor, such as fryers, griddles, etc. In the
event this is unavoidable, ducting will be necessary to supply this unit with an adequate amount
of clean, cool air.
Before using the unit for the first time, ensure it is cleaned properly. Refer to the Cleaning section
for cleaning instructions.
ELECTRICAL CONNECTION
Before making any electrical connection to this unit, check that the power supply is adequate for
the voltage, amperage, and requirements stated on the rating plate. These units will utilize a factory
attached 6-20P plug [ISC35] or 6-15P plug [ISC25] and will require an appropriate receptacle. Make
certain to disconnect the unit from the power source before installing or removing any parts as this
is a high voltage unit. Be absolutely sure that the ground connection for the receptacle is properly
wired. Do not connect equipment to power without proper ground connections. Improper grounding
may result in personal injury or fatality.
DO NOT CUT OR REMOVE THE PLUG OR
GROUNDING PRONG FROM THE PLUG.
CONNECT/PLUG UNIT INTO DEDICATED
AC LINE ONLY SPECIFIED ON THE DATA
PLATE OF THE UNIT.
MAKE CERTAIN THE UNIT IS POWERED
OFF AND UNPLUGGED PRIOR TO ANY
REPAIRS OR MOVEMENT. ALL REPAIRS
SHOULD BE PERFORMED BY AUTHORIZED
SERVICE TECHNICIANS ONLY.
DO NOT HOSE DOWN THE UNIT OR THE
TABLE/COUNTER IF THE UNIT IS ON THE
TABLE/COUNTER.
DO NOT IMMERSE OR LET THE UNIT STAND
IN WATER.
KEEP AWAY FROM RUNNING WATER.
3
Advertisement
Table of Contents
