Page 1
This manual must be read and understood by all persons using or installing this appliance. Contact your Wells dealer if you have any questions concerning installation, use, or maintenance of this equipment. DO NOT DISCARD THIS MANUAL. ISC25 2M-Z21948 Rev.
Page 2
Wells products. This warranty is void if it is determined that, upon inspection by an authorized service agency, the equipment has been modifi ed, misused, misapplied, improperly installed, or damaged in transit or by fi re, fl ood or act of God.
TABLE OF CONTENTS Warranty Specifications General Information Safety Information Installation Information Daily Operation Cleaning Troubleshooting and Replacement Parts Wiring Diagram...
It is 1 inch (25 mm) from the right side on both models and 6 inches (152 mm) from the back on ISC35 models and 4.5 inches (114 mm) from the back o ISC25 models. VOLTS APPROX.
Using any part other than genuine Wells factory supplied parts relieves the manufacturer of all liability. Due to periodic changes in designs, methods, procedures, policies, and regulations, the specifi cations contained in this document are subject to change without notice.
SAFETY INFORMATION This equipment is designed and sold for commercial use only, and is intended for use by personnel trained and experienced in its operation. This is not sold for consumer use in and around the home nor for use directly by the general public in food service locations. Before using your new equipment, read and understand all the instructions and labels associated with the unit prior to putting it into operation.
These units will utilize a factory attached 6-20P plug [ISC35] or 6-15P plug [ISC25] and will require an appropriate receptacle. Make certain to disconnect the unit from the power source before installing or removing any parts as this is a high voltage unit.
OPERATION CERTAIN SURFACES ARE EXTREMELY HOT DURING OPERATION AND CARE SHOULD BE TAKEN WHILE USING THIS UNIT. DO NOT LEAVE THE UNIT IN OPERATION WITHOUT AN ATTENDANT. DO NOT LEAVE THE UNIT ON DURING IDLE PERIODS. DO NOT CYCLE THE POWER QUICKLY ON AND OFF AS THIS MAY CAUSE DAMAGE TO THE UNIT OVER TIME.
CLEANING & MAINTENANCE DO NOT USE COARSE SPONGES/PADS WHICH WILL SCRATCH THE FINISH. CLEANING PROCEDURE DO NOT USE CAUSTIC CLEANERS, Preventive maintenance consists of the following DEGREASERS, FLAMMABLE CLEANERS, recommended cleaning procedures. To keep your OR ANY OTHER CLEANER WHICH CAN unit in its best operating condition, these steps DAMAGE THE COOKING AREA SURFACE.
Contact an authorized service agent or technical support. REPLACEMENT PARTS LIST PART NUMBER DESCRIPTION MODEL 2Q-Z21990 ceramic glass 2E-Z21992 control switch ISC35 2E-Z22077 control switch ISC25 2J-Z21994 main circuit board 2J-Z21995 control board 2T-Z21997 coil temperature sensor 2E-Z21999 LED display 2U-Z22008 centrifugal fan 2U-Z22009...