Maintenance Of Rubber Belt - cec TL2N Owner's Manual

CD TRANSPORT TL2N

Maintenance of Rubber Belt

Periodical maintenance or check is not required for a rubber belt used for all CEC belt-drive
CD transports and players. However, the tension of the belt may be lowered by using for years
which may result unstable reading of information on CD, noise during music reproduction
and/or jump of the music. The replacement of the belt may solve the problem if it comes from
weaker tension of the belt. If replacement of a belt does not solve the problem, consult with the
dealer that you have purchased. An average of the life of a belt is 5 years. It is not required to
replace if musc reproduction goes well even after 5 years.
Replacement of a spindle rubber belt
No other rubber band than CEC original rubber belt can be used for replacement.
Require the CEC belt at the dealer that you have purchased.
A feed belt should be replaced at the dealer or service center because it is located under
both of the pick-up and mechanism covers.
Remove the old spindle belt.
Mount a new belt to the groove under the CD-Turntable through the clearance between
pick-up cover and CD-Turntable.
motor pulley
Then mount the belt to the motor pulley groove. Using a pair of tweezers would be easier
to mount.
Be sure the belt is installed at the grooves and the belt is not twisted. Twist of the belt
can be corrected easily by using a pair of tweezers moving the center shaft by hand.
22
CD-turntable pick-up cover
mechanism cover
feed belt
side view
groove under CD-turntable
motor pulley groove
side view
side view
succeeded replacing the belt