Hilti TE25 Instruction Manual page 4

Keyless Chuck
Optional chuck for drilling in wood / steel or plastic using smooth shank bits.
Item no. Description
" Keyless Chuck
000302018 1 /
2
Bit / Accessory Letter Code: Code = Drill
Servicing
All repairs and adjustments to the Hilti TE25 including inspection
and replacement of brushes, switch, and power cord, should be
performed at a Hilti-Repair Center. When servicing use only
identical replacement parts, as shown on the parts list.
Manufacturer's warranty – tools
Hilti warrants that the tool supplied is free of defects in material and
workmanship. This warranty is valid so long as the tool is operat-
ed and handled correctly, cleaned and serviced properly and in
accordance with the Hilti Operating Instructions, and the technical
system is maintained. This means that only original Hilti consum-
ables, components and spare parts may be used in the tool.
This warranty provides the free-of-charge repair or replacement
of defective parts only over the entire lifespan of the tool. Parts
requiring repair or replacement as a result of normal wear and
tear are not covered by this warranty.
Additional claims are excluded, unless stringent national
rules prohibit such exclusion. In particular, Hilti is not oblig-
Fastening systems
Hilti ® is a registered trademark of Hilti Corp.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070809 / 000 / 00
Preventive maintenance
Check for worn or frayed cord. Keep the air passages for the
motor clear of dirt and dust. The TE25 is permanently lubricated.
ated for direct, indirect, incidental or consequential dam-
ages, losses or expenses in connection with, or by reason of,
the use of, or inability to use the tool for any purpose.
Implied warranties of merchantability or fitness for a partic-
ular purpose are specifically excluded.
For repair or replacement, send tool or related parts immediate-
ly upon discovery of the defect to the address of the local Hilti
marketing organization provided.
This constitutes Hilti's entire obligation with regard to warranty
and supersedes all prior or contemporaneous comments and
oral or written agreements concerning warranties.
5400 South 122 th East Avenue
Tulsa, Oklahoma 74146
Telephone (918) 252-6000
© Copyright 1997 by Hilt Inc. W 2077 4/06 Pos. 3 Ge
For use with:
" Diameter
Smooth Shank Bits to 1 /
2
TE-C (SDS-Plus) = TE10 / TE10 A / TE12 / TE12 S / TE14 / TE17 / TE18
TE-C TE22 / TE22-P / GP22
* These bits for TE12 S / TE14 / TE17 / TE18 / TE22 / TE22-P / GP22
1 Printed in Liechtenstein © 2006 Hilti is an equal opportunity employer. H-000 9/99