Unpacking / Description - Craftsman 172.417740 Owner's Manual

UNPACKING / DESCRIPTION

WARNING:
! Your tool should NEVER be connected to the power source
when you are assembling parts, making adjustments, installing or removing
grinder discs, cleaning or when it is not in use. Disconnecting the tool will
prevent accidental starting, which could cause serious personal injury.
1. Remove the grinder from the carton and inspect it carefully to make sure
that no breakage or damage has occurred during shipping.
2. Do not discard any of the packing materials until all parts are accounted for.
3. Two Grinding Discs are included.
4. If any of the parts are damaged or missing (refer to PARTS LIST below), return the
grinder for replacement to the retailer from which it was purchased.
PARTS LIST (Fig. 1)
NOTE
: Always refer back to these PARTS LIST numbers for product call-outs
and operation reference.
1. Hand grip areas
2. Anti-vibration auxiliary handle
3. Spindle lock button
4. Grinding disc
5. Grinding disc guard
6. Spanner
7. Inner flange
8. Outer flange
9. Clamp adjustment nut
10. Spindle
2.
11. Guard clamping lever
3.
12. Safety on/off switch
13. Variable speed control
14. Lock-on button
4.
11.
10.
9.
INCLUDED ACCESSORIES
- Spanner
- Anti-Vibration Auxiliary Handle
- Grinding Disc Guard
- (2) Grinding Discs
9
13.
1.
14.
12.
5.
6.
7. 8.
TECHNICAL DATA
Rated Voltage
Rated power input
No load speed
Diameter of grinding discs
Disc size
Disc bore
Spindle thread
Machinery weight
Protection degree
Cord length
OPERATION
WARNING:
! This tool is equipped with a disc guard that is ONLY safe for
grinding operation. The guard is NOT safe for cutting operation. Using this tool for
cutting operation will create a hazard that can result in serious personal injury.
INSTALLING AND ADJUSTING THE DISC GUARD (See Figs. 2A, 2B, 2C)
Make sure the grinder is unplugged before making any adjustments.
For work with grinding discs, the disc guard must be mounted.
The projection on the disc guard (5) ensures that only a guard that fits this
angle grinder can be mounted. Raise the Guard Clamping Lever (See Fig. 2A).
To install the guard align the guard projection with the matching groove on the
spindle housing (See Fig. 2A). Push the guard down as far as it will go.
Rotate the guard to a working position (See Fig. 2B example).
NOTE: Working position is with the closed side of the guard toward the operator and
open side pointing directly away from the operator to provide maximum protection
against sparks and flying debris.
Close the Clamping Lever to tighten (See Fig. 2C).
Fig. 2B
Fig. 2A
Open Guard Clamping Lever
Opened Guard Clamping
Lever
(5)
Projection
Insert and Turn
Working Position (Example)
Counterclockwise
10
120 V ~ 60 Hz
8 A
5500 - 11000 /min
115 mm
4 -1/2''
7/8''
5 /8''- 11
4.85 lb / 2.2 kg
/ II
10 ft
Fig. 2C
Closed Guard Clamping
Lever
(5)
(5)
Working Position (Example)