Connections; Connecting The Speakers - Philips MCD300/93 User Manual

AM/MW loop
antenna
Speaker
(right)
IMPORTANT!
– The type plate is located at the rear of
the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.

Connecting the speakers

Connect the speakers to the SPEAKERS (8Ω)
terminals with two speaker wires. Right speaker
to "R" and left speaker to "L", red wire to "+"
and silver wire to "-". Fully insert the stripped
portion of the speaker wire into the terminal as
shown.
1
TV
AC power cord
2

Connections

FM wire antenna
Notes:
– Ensure that the speaker wires are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Speaker
(left)
41