Tuning to radio stations
1
Press STANDBY-ONB (or B on the
remote) to switch on the last selected source.
2
Press repeatedly SOURCE (or TUNER on
the remote) until FM or MW is displayed.
3
Press and hold TUNING3 / 4 or TU +/- à /
á on the remote until the frequency in the
display starts changing.
➜
Display shows SEARC during automatic
tuning.
➜
After the system tunes to a station of
sufficient reception, display shows its frequency .
●
To tune to a weak station, press briefly and
repeatedly TUNING3 / 4 or TU +/- à / á
on the remote until an optimal reception is
found.
4
Repeat Step 3 if necessary until you find the
desired radio station.
Storing preset radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Manual programmng
1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press PROG on the remote.
➜
"PROG" icon flashes.
3
Press PRESET3/4 or CH +/- (¡ / ™) on the
remote to select the desired preset number.
4
Press PROG on the remote again to store the
radio station.
➜
"PROG" disappears on the display.
●
Repeat steps 1-4 to store other radio stations.
Helpful hints:
– You can erase a preset station by storing
another frequency in its place.
Autostore: automatic programming
Autostore automatically starts programming
radio stations from preset 1. Any previous
presets e.g. manually programmed will be erased.
●
In tuner mode (FM or AM), press and hold
PROG until AUTO appears.
➜
During automatic programming, display shows
AUTO and flashing PROG.
➜
Available stations are programmed (20FM or
20 AM).
➜
After all stations are stored, the first autostore
preset station automatically plays.
Listening to preset radio stations
●
In tuner mode, press PRESET3/4 or CH +/-
(¡ / ™) on the remote to select the desired
preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
Tuner
65