Related Manuals for Unimac Air Metal Shear
Summary of Contents for Unimac Air Metal Shear
- Page 1 AIR METAL SHEAR User Manual RETAIN THIS MANUAL FOR FUTURE REFERENCE PLEASE READ THIS MANUAL CAREFULLY BEFORE USE...
-
Page 2: Table Of Contents
AIR METAL SHEAR Table of Contents Safety ..................................1 Safety Instructions .............................. 1 Set-Up ..................................3 Components and Controls ..........................3 Item Parts ................................3 Unpacking ................................4 Assembly ................................4 Air Supply Set-Up Tips ............................4 Operation ................................. 5 Maintenance ................................ -
Page 3: Safety
AIR METAL SHEAR Safety WARNING! This manual provides critical safety instructions on the proper setup, operation, maintenance, and service of this machine/tool. Save this document, refer to it often, and use it to instruct other operators. Failure to read, understand and follow the instructions in this manual may result in fire or serious personal injury—including amputation, electrocution, or death. - Page 4 AIR METAL SHEAR Use proper air hose. Make sure your air hose is in good condition and is long enough to reach your work without stretching. Secure work. Use clamps or a vise to hold work when practical. It is safer than using your hand and frees both hands to operate tool.
-
Page 5: Set-Up
AIR METAL SHEAR Set-Up Components and Controls Item Parts (Refer to right image) A. Pneumatic Metal Shear......1 B. Quick Disconnect Air Fitting....1 C. Bottle for Oil........1 D. Hex Wrench 4mm......1... -
Page 6: Unpacking
AIR METAL SHEAR Unpacking Your tool was carefully packaged for safe transportation. Remove the packaging materials from around your tool and inspect it. If you discover the tool is damaged, please immediately call our customer service hotline. Save the containers and all packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult. -
Page 7: Operation
AIR METAL SHEAR Operation To complete a typical cutting operation, the following is done: 1. Put on safety goggles and gloves. 2. Mark the cut line, secure the workpiece, and clamp a guide to the workpiece if needed. 3. Determine if the swivel head needs to be rotated for optimum tool control and cut line viewing. -
Page 8: Lubrication
AIR METAL SHEAR Lubrication In most cases for periodic tool use, manual lubrication is sufficient. However, if the tool is to be used on a consistent basis, we recommend installing an automatic oiler to eliminate dry runs and ensure maximum tool life. -
Page 9: Troubleshooting
AIR METAL SHEAR Troubleshooting SYMPTOM POSSIBLE CAUSE SOLUTION Tool runs at normal speed Pneumatic shear is being overloaded Reduce feed pressure. Only cut but bogs down when materials within limits of tool cutting, or tool runs slowly Jaws are dull or loose... - Page 10 AIR METAL SHEAR SYMPTOM POSSIBLE CAUSE SOLUTION trigger is released so throttle valve is free to fully release Throttle valve stuck open Replace throttle valve spring or O-rings Air tool becomes hot or Air tool heats up from insufficient lubrication or a...
- Page 11 Some experts believe the incorrect or prolonged use of almost any product could cause serious injury or death. For information that may reduce your risk of serious injury or death consult thepoints below and additionall y , the information available at www.datastreamserver.com/safety - Consult all documentation, packaging and - The product has been supplied by a general merchandise...
Need help?
Do you have a question about the Air Metal Shear and is the answer not in the manual?
Questions and answers