Contents, Inhalt, Contenu, Inhoud Page Seiten Important Safeguards Wichtige Sicherheitshinweise Before First Use/Preparation Vor der ersten Benutzung/ Vorbereitungen Know Your Filter Lernen Sie Ihren Filter kennen Recommended Filter Media Set Up Empfohlene Filtereinrichtung Set Up Instructions Aufbauanleitung 21-22 Installation 9-11 Installation 23-25 Starting Your Filter...
Important Safeguards To guard against injury, basic safety precautions 8. Do not install or store the appliance where it will be exposed to weather or temperatures below freezing. should be observed, including the following: 1. Read and follow all safety instructions and important 9.
Use Aqua One Genuine Spare Parts Only. See Your attention is drawn particularly to the sections your local Aqua One Dealer and look for the concerning “IMPORTANT SAFEGUARDS” and the number listed below for the spare part you require.
Set Up Instructions 1. Open the filter unit. To do this release the 2 clips through it. Rinse the inside of the canister body in tap located on either side of the filter. Fig 1 water also, remember DO NOT USE ANY SOAPS OR DETERGENTS.
Page 7
Set Up Instructions 8. Prior to installing the head unit, turn it over, remove 11. Place the head unit back on top of the canister the impeller cover extension pipe so you can see the body; ensure the power cord is not jammed between filter head and the canister body.
Installation 1. Remove all remaining components from the plastic 6. Attach one to either hose tail on the quick release bags. tap connector. Push the hose on as far as possible. Screw the collars antic lock wise to lock the hoses into 2.
Installation 11. Refer to Figure 7 to assist you in assembling the intake. You will find that the U Pipe, (a) Locking Nut (b) Fig 6 and Hose Tail (c) come as one piece from the factory. So to do the Surface Skimmer Adjuster, (d) Sleeve (e) and the Surface Skimmer.
10. Turn the UV on. The switch is located behind the frosted panel at the top of the filter on the side. The green LED will illuminate when the UV Lamp is on. NOTE: If you require any further information about starting your filter please consult your Aqua One retailer.
Take to the sink, run hot water through cleaned properly. them to loosen the slime. Run an Aqua One double 9. The sponges can also be rinsed in the bucket ended pipe brush through them, and flush again with of aquarium water (Providing the water is not dirty.
Changing your UV Lamp Trouble Shooting 1. Refer to the previous section Cleaning THE FILTER UNIT IS LEAKING Your Filter, which will detail how to open the 1. Check all O-rings are in place and that they are not Canister filter. damaged or soiled.
Page 14
Trouble Shooting cont’d HEAD UNIT STUCK ON CANISTER BODY Locking lever 1. While pump is still plugged in and running, remove the screw cap from the intake pipe. The intake pipe is the one which feeds the water into the filter unit. This will create an airlock in the canister body.
Specifications Canister Model: Nautilus 2700UVC Number of Media Baskets: 4 Dimensions: 32 x 49 x 32cm Max Aquarium Volume: 400-700L Maximum Flow Rate*: 2700L/hr Max Head Height: 2.0M Filter Volume: 22 Litres UV Wattage: 5W Power Requirements: 220 ~ 240V...
1.0. Terms and Conditions of Guarantee. 1.1. Aqua One warrants to the purchaser, for 2 Years from date of original purchase, to repair or replace goods where fault is found due to defective materials or faulty workmanship and where goods do not operate in accordance with the instructions.