Table of Contents
Advertisement
Chapter 4: Using Your Washer Dryer
Selecting an Operating Cycle
The microprocessor control on your Pipette Washer Dryer allows you to select a
factory-preset wash program, to modify the factory-preset wash programs or to
customize the two user programs. The control panel is shown below.
Programming and Starting a Wash Cycle
Refer to Appendix C: Pipette Washer Dryer Specifications for complete details on
the various factory-preset programs and the options available for customizing the
programs. After you have decided which washer program to use, follow the
instructions below to begin using the washer dryer.
The preset factory programs may be customized to suit specific wash
requirements. All changes made to the programs will be stored in the washer
microprocessor's memory until it is changed again. If a FACTORY RESET is
performed, all inputs entered by the user will be erased and the programs shipped
with the washer will be reinstated. It is possible to customize the following
program parameters:
Start Delay 0 to 8 hours in 1 minute increments
Wash Time 0 to 8 hours in 1 minute increments
Rinse Time 0 to 4 hours in 1 minute increments
Total number of Rinses 0 to 10
Dry time 0 to 8 hours in 1 minute increments
To program and start a wash cycle:
1. Turn the Main Power Switch to on. The display will show the last program
that was run.
2. Press RUN/CANCEL to select this program.
3. If a different program is desired, press MENU to scroll through the three
available programs shown on the display.
20
Product Service 1-800-522-7658
Advertisement
Table of Contents
