Table of Contents
Advertisement
Chapter 3: Getting Started
Installing the Back Splash Assembly and Clear
Cover
Hold the back splash vertically with the three tabs at the bottom and the opening
towards the front of the washer dryer. Align the three tabs into the three
rectangular notches in the tube guide. When the bottom of the back splash is
seated against the top of the tube guide, rotate the back splash slightly counter
clockwise to lock the assembly down. Center the clear cover over the back splash
assembly with the opening toward the back and lower until the bottom of both
handles are nested in the slots on each side of the back splash. Check to make sure
the magnet on the clear cover is aligned with the lid sensor at the front of the tank.
HANDLES NEST
IN SLOT
BACK SPLASH
Connecting the Power Supply
Plug the power cord into the receptacle on the back of the ScrubAir Pipette
Washer Dryer and plug the other end into a suitable wall power receptacle that
matches the rated voltage marked on the serial tag.
CAUTION: Do not use any detachable power cord that is not
!
adequately rated for the unit.
PRUDENCE: Ne pas utliser un fil électrique amovible qui n'est
pas du tension nominale de l'appareil..
14
LID MAGNET SHOULD
BE CENTERED TO
LID SENSOR WHEN
IN PLACE
ENGAUGE TABS
3 PLACES AND
ROTATE COUNTER
CLOCKWISE
TO LOCK
TUBE GUIDE ASSEMBLY
Product Service 1-800-522-7658
Advertisement
Table of Contents
