Operation Procedure - Yamaha NS-BP300 Service Manual

R-840/NS-BP300
● Operation procedure
1. Connect the power cable of this unit to the AC outlet.
The power to this unit is supplied and the microprocessor is in the writing mode.
2. Start up FlashSta.exe.
The screen appears as shown below. (Fig. 2)
3. Select the data to be transmitted and port. (Fig. 2)
• Select Program
Select Internal flash memory
• RS232C
Select the port of RS-232C
* For selection of the port, COM1 to 4 can be used.
As COM5 or higher port cannot be used, select from COM 1 to 4 of the setting on the PC side.
4. Click [Refer...] and select the firmware name. (Fig. 3)
* The ID and MCU Type are loaded automatically when the file is selected. (Fig. 3)
Click [OK]. (Fig. 3)
When [Refer...] is clicked, the "Open" screen appears.
22
Select Internal flash memory
Select the port of RS-232C
Fig. 2
Fig. 3