Determining Sheetmetal Requirements; Turning Vanes - Honeywell F200E Product Data

Fig. 9. Horizontal furnace, with media air filter mounted
vertically in return duct near furnace.
Fig. 10. Two or more media air cleaners used in a high
capacity system.

Determining Sheetmetal Requirements

The media air cleaner is adaptable to all new or existing
forced air heating and cooling systems used in residential
applications. Transitions or turning vanes may be required in
some applications for effective media air cleaner operation.
Transitions
Transitions are needed when the duct is a different size than
the media air cleaner cabinet. Follow these guidelines when
fabricating:
1. Use gradual transitions to reduce air turbulence and
increase efficiency. See Fig. 11.
2. Use no more than 20 degrees (about 4 in. per running
ft. (100 mm per 300 linear mm)) of expansion on each
side of a transition fitting.

Turning Vanes

If the media air cleaner is installed next to an elbow or angle
fitting, add turning vanes inside the angle to distribute airflow
more evenly across the face of the media. See Fig 12.
Offsets
If the duct connection to the furnace in a side installation
allows less than 7 in. (178 mm) for mounting media air
cleaner cabinet, attach an offset to the elbow. See Fig. 13.
DUCT SIZE CHANGED GRADUALLY TO PREVENT TURBULENCE.
20 DEGREE EXPANSION PER SIDE PER
FITTING (4 IN. PER RUNNING FOOT
[100 MM PER 300 LINEAR MM])
M14792
RETURN AIR
DUCT
TRANSITION FITTING
Fig. 11. Duct size changed gradually to prevent
M14793
Fig. 12. Turning vanes installed in bend help distribute
1 REQUIRED TURNING VANES HELP DISTRIBUTE AIRFLOW EVENLY.
Fig. 13. Typical use of duct offset to make room for
5
F200E CHARGED-MEDIA AIR CLEANER
MEDIA AIR CLEANER CABINET
turbulence.
airflow evenly over face of media.
LESS
THAN
7 in.
(178 mm)
media air cleaner.
M947B
TURNING
VANES
M5651
OFFSET
AT LEAST
7 in.
1
(178 mm)
M14794
68-0238