Viewing clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(DISC or TUNER for example)
●
Press briefly CLOCK on the remote.
●
You may press MODE on the set to toggle
between 12-hour and 24-hour display.
➜
The clock is displayed for a few seconds.
➜
If the clock has not been set, "--:--" is
displayed.
Setting clock
1
In standby or power on mode, press and hold
CLOCK on the remote.
➜
The clock digits flash on the display panel.
➜
If the clock has not been set, "--:--" flashes
2
Press ¡ / ™ repeatedly to set the hour.
3
Press à / á repeatedly to set the minute.
4
Press CLOCK agian to store the setting.
➜
The clock starts working.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 15 seconds.
Setting wake-up timer
The system can switch on to DISC or TUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– To set a new timer, you need to
deactivate the previously set timer.
1
In standby mode, press and hold SLEEP/
TIMER on the remote for more than five
seconds to enter timer setting mode.
➜
The current source and timer digits flash on
the display panel.
➜
" NO TIMER " will be displayed briefly if
wake-up timer is not set.
2
Press DISC or TUNER to select the desired
source.
●
Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
TUNER – tune to the desired radio station.
3
Press ¡ / ™ repeatedly to set the hour.
4
Press à / á repeatedly to set the minute.
5
Press SLEEP/TIMER to store the time.
➜
remains on the display.
●
At the preset time, the selected source will play.
To deactivate the wake-up timer
●
In standby mode, press and hold SLEEP/
TIMER until "TIMER OFF " is displayed.
Notes:
– The system will exit timer setting mode if no
button is pressed within 15 seconds.
– Display shows
deactivated.
Setting sleep timer
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press SLEEP/TIMER on the remote control
repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™120 ™ OFF
2
Press SLEEP/TIMER until you reach the
desired length of time.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until "OFF" is
displayed, or press the STANDBY ON y
button.
Clock/Timer
if activated, and disappears if
31