Table of Contents
Advertisement
IMPORTANT!
– Before you operate the system,
complete the connection procedures.
– When the system is switched to Standby
mode, it is still consuming power.To
disconnect the system from the power
supply completely, reomve the AC power
plug from the wall socket.
Switching the system on/off
●
In standby, press STANDBY ONB/
SOURCE on the set, or DISC/TUNER/
AUX on the remote to switch on the system.
➜
"POWER ON" is displayed briefly.
➜
The system will switch to the selected or last
selected source.
To switch the system to standby mode
●
In power-on mode, press and hold STANDBY
ONB (B on the remote).
➜
The clock time will be displayed. Or "--:--"
will be displayed if clock time is not set.
Power saving automatic standby
As a power-saving feature, the system will
automatically switch to Standby mode if you
don't press any button within 30 minutes in the
stop mode.
Basic Operations
Volume control
Press VOLUME (+/-) (or VOL +/- on the
remote) to increase or decrease the volume
level.
➜
The display briefly shows "VOL" and a volume
value from "01" to "39" ( "MIN" or "MAX" is
displayed when adjusted to the lowest or highest
volume level).
To switch off the volume temporarily
●
Press MUTE on the remote.
➜
Playback will continue without sound and
"MUTE" is displayed briefly.
●
To activate sound reproduction, you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Sound Control
DBB (Dynamic Bass Boost)
DBB enhances the bass response.
●
Press DBB to enable or disable DBB feature.
➜
If DBB is activated, "DBB" will be shown.
Helpful hints:
– Some discs might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off DBB or reduce the
volume.
DSC (Digital Sound Control)
DSC provides a different type of preset sound
equalizer setting.
●
Press DSC on the remote (or on the system)
repeatedly to select:
CLASSIC, ROCK, JAZZ or POP
➜
The display shows the selected sound setting.
19
Advertisement
Table of Contents
Troubleshooting
