Select Menu Display Language; Use Philips Easylink; Turn On Progressive Scan - Philips HES4900/98 User Manual

2
Turn on the TV and switch to the correct
video-in channel. (See the TV user manual
on how to select the correct input.)

Select menu display language

1
Press OPTIONS.
2
Select [General Setup].
3
Select [OSD Language] and then press .
4
Select a setting and then press OK.
5
To exit the menu, press

Use Philips EasyLink

This unit supports Philips EasyLink, which
uses the HDMI CEC (Consumer Electronics
Control) protocol. EasyLink-compliant devices
that are connected through HDMI connectors
can be controlled by a single remote control.
Note
•
Philips does not guarantee 100% interoperability with
all HDMI CEC devices.
1
Turn on the HDMI CEC operations on the
TV or other connected devices. See TVs/
devices manual for details.
2
You can now enjoy the following Philips
EasyLink controls.
18 EN
OPTIONS.
One touch play[Auto Wakeup TV]
When you press
from standby mode and start disc play (if a
video disc is found in the disc compartment).
At the same time, your TV will also be turned
on and be switched to the correct viewing
channel.
One touch power-off[System Standby]
When you connect this unit to devices that
support standby mode, you can use the
remote control of this unit to switch this unit
and all connected HDMI devices to standby
mode. You can also use the remote control
from any of the connected HDMI devices to
perform one-touch standby .
One touch audio play[System Audio Control]
When you connect this unit to HDMI
CEC compliant devices, the unit can switch
automatically to play audio from the
connected device.

Turn on Progressive Scan

Progressive scan displays twice the number of
frames per seconds than interlaced scanning
(ordinary TV system). With nearly double the
number of lines, progressive scan offers higher
picture resolution and quality.
Before you turn on this feature, ensure that:
• The TV supports progressive scan
signals.
• You have connected this unit with the
TV through component video.
1
Turn on the TV.
2
Ensure that the TV progressive scan mode
is deactivated (see the TV user manual).
3
Switch the TV to the correct viewing
channel for this unit.
4
Press DISC.
5
Press OPTIONS.
6
Press / to select [Video Setup] in the
menu, then press .
, this unit will wake up