Configuration / Operating The Function Keys - PR 5714 Manual

CONFIGURATION / OPERATING THE
Documentation for routing diagram.
In general:
When configuring the display you are guided through all parameters, you can
choose the settings which fit the application. For each menu there is a scrol-
ling help text which is automatically shown in the display, this starts after 5
seconds if no key has been activated.
Configuration is carried out by using the 3 function keys.
will increase the numerical value or choose the next parameter.
1
will decrease the numerical value or choose the previous parameter.
2
will accept the chosen value and end the menu.
3
If a function does not exist in the display all parameters are skipped to make the
configuration as simple as possible.
Once the configuration has been entered the display will show "----".
Pressing and holding
state (1.0) without saving the changed values or parameters.
If no key is activated for 2 minutes, the display will return to the default state
(1.0) without saving the changed values or parameters.
Further explanations:
Fast setpoint adjustment and relay test: These menus allow you to change the
set point quickly and to check the operation of the relays.
Pressing and
1 2
is indicated by the diodes on the display. Pressing
change.
Holding down
3
te without changing the set point.
Password protection:
Using a password will stop access to the menu and parameters. There are two
levels of password protection. Passwords between 0000...4999 allow access to
the fast set point adjustment and relay test. (Using this password stops access
to all other parts of the menu). Passwords between 5000...9999 stop access
to all parts of the menu, fast set point and relay test. (Current set point is still
shown). By using the master password 2008, all configuration menus are avai-
lable.
20
FUNCTION KEYS
will return to the previous menu or return to the default
3
at the same time will change the state of the relay – this change
for more than 0.5 seconds will return the unit to the default sta-
5714V103-UK
will save the set point
3