Heatilator GCDC60 Installation & Operating Instructions Manual page 18

6. Place the Lava Rock and Vermiculite
See Figures 21-23. It is not necessary to use the entire
bag. Save the remaining amount for future use.
7. Place the Rock Wool
Place a small amount of 1/2 in. diameter pieces
(dime-size) of rock wool on the burner pan so that the
rock wool touches but does not cover the holes in the
burner pan. This will provide the "glowing embers"
look. As with the lava rock and vermiculite, it is not
necessary to use the entire bag. Save the remaining
for future use. See Figures 22 and 24.
8. Place the Fire Glow
Fire glow (FIRE98) is a flame colorant material that
also adds to the realism of the gas appliance flame.
After placing the rock wool in the appliance, sprinkle
some of the fire glow on top of the burner. As with the
lava rock, vermiculite and rock wool, it is not necessary
to use the entire bag. Save the remaining for future
use. See Figure 25.
f i r e - p a r t s . c o m
9. Replace the Glass
Replace the glass as shown on page 24.
10. Replace the Control Access Panel
See Figure 26.
11. Replace the Upper Grille Panel
Figure 21 - Placing Lava Rock
Figure 22 - Placing the Vermiculite, Lava Rock, Rock
18
Wool and Fire Glow.
CALIBER B-VENT INSTALLATION INSTRUCTIONS
Figure 23 - Placing the Vermiculite
Figure 24 - Placing the Rock Wool
Figure 25 - Placing the Fire Glow
Figure 26 - Replace the Control Access Panel
31282 Rev Q 09/04