Use Philips Easylink; Play; Play A Disc; Play Video - Philips DVP4320WH User Manual

4
Select [Progressive] > [On], then press OK.
»
A warning message is displayed.
5
To proceed, select [Ok] and press OK.
»
The progressive setup is complete.
Note
•
If a blank/distorted screen is displayed, wait for 15
seconds for the auto recovery.
•
If no picture is displayed, turn off the progressive scan
mode as follows:
•
1) Press to open the disc compartment.
•
2) Press the Numeric button '1'.
6
Press SETUP to exit the menu.
7
You can now turn on the progressive scan
mode on the TV (refer to the TV user manual).
Note
•
During play, when the progressive scan mode is on for
both this product and the TV, distorted picture may
display. In this case, turn off the progressive scan feature
on both this product and the TV.

Use Philips EasyLink

This product supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
Note
•
To enable the EasyLink feature, you must turn on the HDMI
CEC operations on the TV and on other devices connected
to TV. Refer to the TVs/devices manual for details.
One-touch play
1
Press the STANDBY
product.
»
The TV (if supports one-touch play)
automatically turns on and switches to the
correct video-in channel.
»
If a disc is loaded in this product, disc play
automatically starts.
One-touch standby
1
Press and hold the STANDBY
remote control.
»
All the connected devices (if the device
supports one-touch standby) automatically
switch to standby.
10 EN
button to turn on this
button on the
Note
•
Philips does not guarantee 100% interoperability with all
HDMI CEC devices.

5 Play

Play a disc

Caution
•
Do not place any objects other than discs into the disc
compartment.
•
Do not touch the disc optical lens inside the disc
compartment.
1
Press PUSH TO OPEN to open the disc
compartment.
2
Load a disc with its label facing up.
3
Close the disc compartment and start disc
play.
• To view disc play, turn on the TV to the
correct viewing channel for this product.
• To stop disc play, press
Note
•
Check the types of discs supported (see "Specifications"
> "Play media").
•
If the password entry menu is displayed, enter the
password before you can play the locked or restricted
disc (see "Adjust settings" > "Preferences" > [Parental
Control]).
•
If you pause or stop a disc, the screen saver appears after
5 minutes of inactivity. To deactivate the screen saver,
press DISC MENU.
•
After you pause or stop a disc and no button is pressed
within 15 minutes, this product automatically switches
to standby.

Play video

Note
•
Some operations may not work with some discs. See the
information accompanying the disc for details.
Control video play
1
Play a title.
2
Use the remote control to control the play.
.