Sony HT-ST5000 Operating Instructions Manual page 66

Headphones Connection via
BLUETOOTH
BLUETOOTH connection cannot be
completed.
 Make sure that the BLUETOOTH
indicator of the main unit is lit
(page 10).
 Make sure the BLUETOOTH device to
be connected with is turned on and
the BLUETOOTH function is enabled.
 Bring this system and the
BLUETOOTH device closer together.
 Pair this system and the BLUETOOTH
device again. You may need to cancel
the pairing with this system using
your BLUETOOTH device first.
 Pairing information may be deleted.
Perform pairing operation again
(page 36).
Pairing cannot be achieved.
 Bring this system and the
BLUETOOTH device closer together.
 Make sure this system is not receiving
interference from a wireless LAN
device, other 2.4 GHz wireless
devices, or a microwave oven. If a
device that generates
electromagnetic radiation is nearby,
move the device away from this
system.
You cannot use the NFC function.
 The NFC function does not work with
BLUETOOTH-compatible
headphones. To listen to sound using
a BLUETOOTH-compatible
headphones, see "Listening to Sound
of the Connected TV or Device from
Headphones" (page 36).
No sound is output from the
connected BLUETOOTH
headphones.
 Make sure that the BLUETOOTH
indicator of the main unit is lit
(page 10).
66
GB
 Bring this system and the
BLUETOOTH device closer together.
 If a device that generates
electromagnetic radiation, such as a
wireless LAN device, other
BLUETOOTH devices, or a microwave
oven is nearby, move the device away
from this system.
 Remove any obstacle between this
system and the BLUETOOTH device or
move this system away from the
obstacle.
 Reposition the connected
BLUETOOTH device.
 Switch the wireless LAN frequency of
any nearby wireless LAN router or PC
to 5 GHz range.
 Increase the volume on the
connected BLUETOOTH device.
 Set [Wireless Playback Quality] to
[Connection] (page 56).
Wired LAN Connection
The system cannot connect to the
network.
 Check the network connection
(page 20) and the network settings
(page 58).
Wireless LAN Connection
You cannot connect your PC to the
Internet after [Wi-Fi Protected
Setup™ (WPS)] is performed.
 The wireless settings of the router
may change automatically if you use
the Wi-Fi Protected Setup function
before adjusting the settings of the
router. In this case, change the
wireless settings of your PC
accordingly.