PROVING UNITS
1 SAFETY INFORMATION
REMEMBER: SAFETY IS NO ACCIDENT
These instructions contain both information and warnings that are
necessary for the safe operation and maintenance of this product. It
is recommended that you read the instructions carefully and ensure
that the contents are fully understood. Failure to understand and
to comply with the warnings and instructions can result in serious
injury, damage or even death.
Particular attention should be paid to the Warnings, Precautions and
Technical Specifications.
Please keep these instructions for future reference.
Updated instructions and product information are available at:
www.martindale-electric.co.uk
1.1 Meaning of Symbols and Markings
Caution - risk of danger & refer to instructions
Caution - risk of electric shock
Equipment protected by double or reinforced
insulation (Class II)
Equipment complies with relevant EU Directives
End of life disposal of this equipment should be in
accordance with relevant EU Directives
Instruction
Manual
PD430
PD440
PD690
PD700
PD710
1
ALWAYS READ THESE INSTRUCTIONS BEFORE PROCEEDING
Thank you for buying one of our products. For safety and full
understanding of its benefits please read this manual before use.
Technical support is available from 01923 441717 and
support@martindale-electric.co.uk.
CONTENTS
1
Safety Information
1.1 Meaning of Symbols and Markings
1.2 Precautions
2
Introduction
2.1 Inspection
2.2 Description
2.3 Accessories
2.4 Battery Installation
3
Operation
3.1 Proving Unit LED Indications
3.2 Using the External Power Socket
3.3 Proving a Test Lamp, Voltage Tester/Indicator, DMM, etc.
3.4 Test Lamp, Voltage Tester/Indicator Cables
4
Maintenance
4.1 Battery Replacement
4.2 Cleaning
4.3 Repair and Service
4.4 Storage Conditions
5
Warranty
Specifications
1.2 Precautions
This product has been designed with your safety in mind, but please
pay attention to the following warnings and cautions before use.
Warnings
In order to avoid the danger of electrical shock, it is important that
proper safety measures are taken when working with voltages
exceeding 30V AC rms, 42V AC peak or 60V DC.
Before use check the unit for cracks or any other damage. Make
sure the unit is free from dust, grease and moisture. Also check any
associated accessories for damage. Do not use if damaged.
Do not use if the battery cover is not fitted.
Do not apply greater than 12V DC to the external power socket.
Cautions
Avoid severe mechanical shock or vibration and extreme temperature.
To avoid corrosion from leaking batteries, remove the batteries when
the unit is not in use for an extended period.
Limit the test time to less than 10 seconds.
Do not short the output terminals.
2
1
1
2
3
3
3
4
4
5
5
5
7
7
8
8
8
8
9
10