Jib Furler - Hobie teddy Owner's Manual

Ref : MM_TEDDY
HOBIE TEDDY
ASSEMBLY MANUAL

Jib furler

Illustration
www.hobiecat.com
Issued by : IR Date : 01/2015 Up-date : 2
Steps Description
Take the jib tack line in the rope bag and the furler
in the rig bag.
Lead the jib halyard line to the small block on the
1
end of the jib halyard wire (that has been fixed at
the top of the mast at the previous step) Do a loop
and secure with a Figure 8 knot.
Shackle the jib furler to the bridles using the 6mm
shackle provided. Ensure that the exit hole in the
furler is pointing towards the furler cleat on the
2
front crossbar. Check that the screw on the under-
side of the furler is tight. This prevents the outer
cover from rotating.
Wind the furler up in a clockwise direction.
Leave enough furler line to reach the furler
3
cleat.
Page : 19/32