Operating Procedures - Cushman Spraytek DS175 Safety & Operation Manual

5 OPERATION
5.3

OPERATING PROCEDURES_________________________________________________

A Rollover Protection Structure (ROPS) for this utility vehicle is included as standard equipment. Seat belts must be
worn whenever a ROPS is installed on the vehicle. Always keep seat belt snugly adjusted. DO NOT use seat belts
on a utility vehicle without a ROPS.
If a ROPS is installed and the vehicle is overturning, hold onto the steering wheel. Do not attempt to jump out or
leave the seat.
To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection. Wear any
protective equipment recommended by the chemical manufacturer.
1. Under no circumstances should the engine be
started without the operator seated in the vehicle.
2. Do not operate utility vehicle or attachments with
loose, damaged, or missing components. Whenever
possible spray when grass is dry.
3. Never remove or install the engine cover while the
engine is running. The engine cover is a machinery
guard and its removal exposes you to moving parts.
Keep hands, hair, and clothing away from flywheel,
radiator cooling fan, alternator fan, engine belts,
pulleys, and air intake.
!
WARNING
Failure to latch the engine cover properly can result in
the engine cover tipping forward causing loss of
control of the vehicle and possible personal injury.
4. First spray using water in a test area to become
thoroughly familiar with the operation of the truck
and sprayer.
5. Study the area to determine the best and safest
operating procedure. Consider the type of terrain,
and condition of the surface. Each condition will
require certain adjustments or precautions.
6. Never direct discharge
bystanders, nor allow anyone near the machine
while in operation.
responsible for injuries inflicted to bystanders and/or
damage to their property.
18
!
WARNING
!
CAUTION
of material toward
The owner/operator
Before spraying, pick up all debris such as rocks, toys,
and wire which can be thrown by the machine. Enter a
new area cautiously. Always operate at speeds that
allow you to have complete control of the sprayer.
7. Always turn pump switch off when not spraying.
8. Disengage the sprayer pump and raise the booms
when crossing paths or roadways. Look out for
traffic.
9. Stop and inspect the equipment for damage
immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
!
Before you clean, adjust, or repair this equipment,
always disengage sprayer pump, lower booms to the
ground, engage parking brake, stop engine, and
remove key from ignition switch to prevent injuries.
10. Slow down and use extra care on hillsides. Read
Section 5.9. Use caution when operating near drop
offs.
11. Look behind and down before backing up to be sure
is
the path is clear. Use care when approaching blind
corners, shrubs, trees, or other objects that may
obscure vision.
!
CAUTION
WARNING