Sprayer Control Systems - Cushman Spraytek DS175 Safety & Operation Manual

X. Accelerator Pedal - Push pedal down to open
throttle (increase speed), release to return throttle to
idle position (decrease speed).
Y. Sprayer Control Mount
Used to mount sprayer control.
AA
Z
AB
Z. Parking Brake Lever
The park brake lever is located to the left side of the
drivers seat. Whenever using the parking brake, shift
transmission to 1st Gear, and shut off engine.
To engage the brake, pull up on the lever until park
brake is applied.
To release; while slightly pulling up on the handle,
push the button at the end of the lever and while
holding the button in, lower the lever to it's original
position.
4.3

SPRAYER CONTROL SYSTEMS______________________________________________

There are three different sprayer control systems that can
be used with this sprayer. The sprayer control systems do
not come with the Spraytek and must be ordered
separately.
AE
AC
AD
AF
Figure 4F
AA. Differential Shift Cable
Used to shift differential from LOW to
HIGH speed range. Do not shift
differential while vehicle is moving.
Push handle all the way down to shift
differential into LOW speed range.
Pull handle up all the way to shift
differential into HIGH speed range.
Placing handle in middle detent position places the
differential in NEUTRAL. Parking brake must be
engaged or service pedal depressed with differential
in NEUTRAL to prevent the vehicle moving.
Spraying operations
differential in LOW speed range
AB. Sprayer Pump Switch
Used to engage and disengage sprayer pump. Do
not allow pump to run dry. Permanent damage may
result.
AC. Agitation Control Handle
Controls the amount of liquid passing through the
nozzles allowing complete agitation for mixing loaded
chemicals with carrier (water). It is recommended to
leave this valve fully open at all times even with low
tank liquid level.
AD. Boom/Hose Supply Valve
Allows isolated use of either the hose reel or the
boom. The hose reel position allows hook-up to a
hand-held spray gun or walking type spray boom.
The boom position allows use of all spray boom
accessories.
AE. Boom Valve
Needs to be open if the Boom/Hose Supply Valve
(AC) is in the boom position, if the selector valve is in
the hose reel position, this control valve needs to be
in the closed position.
AF. Suction Valve
Needs to be in the open position for normal
operation. If the pump and/or the filter need servicing
or repair, this valve can be turned to the closed
position (with liquid in the tank) allowing these items
to be worked on.
All information pertaining to the set-up and installation of
the booms and control systems is furnished with the
accessory.
CONTROLS
must be performed
4
with
15