To Display The Dvd Mode Screen; If A Menu Screen Appears - Alpine IVA-W520E Operating Instructions Manual

To display the DVD mode screen

• If you try to activate the auxiliary device while driving, the display
will show the warning-Picture off for your safety.
Caution
• Not all functions will operate for every DVD. See the
individual DVD's instructions for details on the
features supported.
• Fingerprints on a disc may adversely affect
playback. If a problem occurs, remove the disc and
check for fingerprints on the playback side. Clean
the disc if necessary.
• If you switch the power or Ignition key OFF or change
sources during playback, playback will continue
where you left off when you resume playback.
• If you try to perform an invalid operation (based on
the type of disc being played), the following mark is
displayed on the monitor screen:
• Play Position Memory Function
Even if you turn power off or switch the Ignition key
to OFF during playback or change the source,
playback will continue from the point where
playback stopped when the power is turned ON
again.
1
Press SOURCE/ on the unit.
The SOURCE selection screen is displayed.
2
Touch [Disc].
The display shows the DISC mode screen.
Insert a disc with the label side facing up. The unit starts to
play the disc.
When an optional Alpine DVD player is connected:
Insert a disc into the DVD/CD player, the player starts
playing.
• The operation screen changes to the visual screen in the DVD or
Video CD mode for 5 seconds after an operation has been performed.
Touch the display panel to display the operation screen again.
• The display mode can be changed by touching [WIDE].
For operation, see "Switching Display Modes" on page 23.
Inserting/Ejecting a Disc
Refer to "Inserting/Ejecting a Disc" (page 11).
• The reverse side of a double-sided DVD will not be played
automatically.
Remove the disc, turn it over, and reinsert it.
• Do not insert discs containing maps for the navigation system. Doing
so could result in damage.
• Refer also to "DVD Setup" (page 24 to 26).
• Be sure the remote input lead is connected to the remote output lead
of this unit when a DVD changer or DVD player is connected. If not
correctly connected, touch operation cannot be performed.

If a menu screen appears

On DVD mode, menu screens may appear automatically. If this
happens, perform the operation described below to start playback.
Direct Menu Operations
1 Touch the DVD menu directly.
• Some operations cannot be performed depending on the disc.
Menu Operations
1 Touch [Control] to display the operation keys.
2 Touch [Key].
The menu operation mode will be displayed.
Touch [Return] to return to the previous display.
3 Select a desired menu item by touching [ ], [ ], [ ] or
[ ].
4 Touch [Enter] to confirm the selected item.
17
-EN