Table of Contents
Advertisement
4 Get started
Prepare the remote control
1
Open the battery compartment.
2
Insert two R03 or AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Caution
Remove batteries if they are exhausted or if the remote
control is not to be used for a long time.
Do not mix batteries (old and new or carbon and
alkaline, etc.).
Batteries contain chemical substances, so they should be
disposed of properly.
Find the correct viewing channel
1
Press
to turn on this product.
2
Turn on the TV and switch to the correct
video-in channel. (Refer to the TV user manual
on how to select the correct channel.)
Select menu display language
The language options may vary from
different regions.
1
Press SETUP.
» [General Setup] menu is displayed.
2
Select [OSD language], then press .
3
Press
to select a language, then press OK.
8
EN
Turn on progressive scan
Note
To use the progressive scan feature, you must connect
a progressive scan TV with the component video jacks
(see "Connect" > "Connect video cables" > "Option 1:
Connect to the component video jacks" for details).
1
Turn on the TV to the correct viewing channel
for this product.
2
Press SETUP.
3
Press
to select [Video Setup].
4
Select [Progressive] > [On], then press OK.
»
A warning message is displayed.
5
To proceed, select [Ok] and press OK.
»
The progressive setup is complete.
Note
If a blank/distorted screen is displayed, wait for 15
seconds for the auto recovery.
If no picture is displayed, turn off the progressive scan
mode as follows:
1) Press
to open the disc compartment.
2) Press the Numeric button '1'.
6
Press SETUP to exit the menu.
7
You can now turn on the progressive scan
mode on the TV (see the TV user manual).
Note
During play, when the progressive scan mode is on for
both this product and the TV, distorted picture may
display. In this case, turn off the progressive scan feature
on both this product and the TV.
Advertisement
Table of Contents
