Turning On The Power - Olimpus IPLEX RT Operation Manual

3. Attach the optical adapter (optionally available)
1) Remove the tip cap.
2) Positioning the optical adapter with the distal end so they are directly opposite each other, carefully
insert the optical adapter into the distal end.
Optical adapter
positioning groove
Connecting screw thread
Distal end
3) Turn the optical adapter nut clockwise until the first
screw thread passes over the connecting screw thread.
4) Once past the first screw thread, turn the entire main
body of the optical adapter clockwise while pushing
gently until it fits into the positioning cut surface on the
insertion tube's distal end and can be turned no further.
5) Turn the nut of the optical adapter clockwise until the
second screw thread is screwed onto the connecting
screw thread. Tighten the nut until it stops.
6) Press the LIGHT button ( ) on the front panel to light
the illumination.
CAUTION
• Store the tip cap for future use.
• Do not use tools to tighten or release the optical tip adapter.
• Optical tip adapter is double-threaded. Attach it firmly by turning the nut clockwise until fully seated.
• Make sure that the O-ring on the insertion tube distal end did not detach after removing the tip cap.
• When using the stereo optical adapter, refer to the IPLEX RX/RT instruction manual.

4. Turning on the power

Hold down the main unit's power button ( ) until a short
beep is generated and confirm that the power turns on.
Turning ON the power will light the illumination automati-
cally.
Press the LIGHT button ( ) on the front panel to select
ON/OFF of the illumination.
Second screw thread
O-ring
First screw thread
6-mm type
You are now ready to use your IPLEX RX/RT.
Nut
Optical adapter Distal end
Second screw thread
First screw thread
- 2 -
Optical adapter
positioning cut surface
O-ring
Connecting screw thread
4-mm type
Optical adapter
Optical adapter main body
Power button ( )
Nut
Optical adapter