Attention To Be Paid At The Time Of Installation; Attention To Be Paid At The Time Of Using - HASHIMA HP-450CS Instruction Manual

Attention to be paid at the time of installation

1. Install this machine, which weights 152kg, in regard to the 450C/CS
respectively, on the robust foundation horizontally.
2. Don't install this machine near the object easy to burn, as it generates high
temperature when it has been put into use. Exclude, in addition, dusts and
others stuck onto this machine periodically.
3. Connect the machine to an exclusive power source corresponding with the
ratio consumption power by referring to the specifications.
4. Don't fail to the ground .By the way ,it has no relations to the rotary direction
of the belt.
5. In the case where you change the power source plug or lengthen construction
shop near by.
6. When the machine has been brought in or when it has been transferred, don't
fail to remove the main unit's cover, before ensuring that the upper and lower
belt warping prevention limit switches place correctly the belt between them
from both sides. (Refer to next page.)

Attention to be paid at the time of using

1. Don't fail to read the User's Manual prior to the usage.
2. Don't fail to remove the main unit's cover and ensure that the upper and lower
warp prevention limit switches place correctly the belt between them from
both sides, before connecting the power source. (Refer to next page.)
3. Wipe off dusts using a dry floor mat, before inserting the material.
4. Pay sufficient attention not to make contact with the belt and the upper cover
whose temperature rises high nor mount things on them.
5. Don't absolutely put your hands on to the roller inside the machine beyond the
necessity at the time you insert the material for fear that they might be
caught in.
6. Don't put any things to the main unit of the press except the materials to be
inserted.
7. Disconnect the power source breaker immediately and insert the manual
handle (an accessory) to the emergency screw, then, turn it to the arrow
marked direction in order to remove the unusual things before the operation,
if they have been inserted.
8. When the material, has twined rounded the strip off device at the exit of the
material, don't fail to disconnect the power source breaker, before removing it.