Subscribe to Our Youtube Channel
Related Manuals for FreeWave V10a
Summary of Contents for FreeWave V10a
- Page 1 900 MHz High Throughput Wireless Modem Installation Guide V1.0a FreeWave Technologies Inc. 1880 S Flatiron Ct. / Suite F Boulder, CO 80301 303-444-3863 1 of 8 LIG0006AA Rev A...
-
Page 2: Installation Guide
900 MHz High Throughput Wireless Modem Installation Guide This installation guide covers all models of the FreeWave Technologies 900 MHz High Throughput DST transceivers sold under FCC ID KNY-820181531119. All transceiver models sold under FCC ID KNY-820181531119 must be installed professionally. - Page 3 ♦ Consult the dealer or an experienced radio/TV technician for help. Note: Whenever any FreeWave Technologies module is placed inside an enclosure a label must be placed on the outside of that enclosure which includes the module's FCC ID.
- Page 4 Larsen YA6-900-W EAN0906YA NOTE: Use of this antenna requires a cable equivalent to FreeWave part # ASC0302xx. This is a 30’ LMR-240 cable and will provide ~2.3dB of attenuation, allowing the transceiver to run at full power. 900MHz Omni-directional Antennas...
- Page 5 Table 1 below provides the maximum output power settings for FGR-HT FreeWave transceivers at given antenna gain (10 dB and 6 dB Yagi antennas are given as an example) and cable loss combinations.
- Page 6 EIRP does not exceed 36 dBm. WARNING: Any antenna other than listed in this section needs to be approved by FreeWave Technologies before its use to assure that the transceiver in combination with the new antenna meets FCC requirements.
- Page 7 Placement of the FreeWave transceiver is likely to have a significant impact on its performance. In general, the rule of thumb with FreeWave is that the higher the placement of the antenna the better the communication link - height is everything! In practice you should also place the transceiver away from computers, telephones, answering machines, and other similar equipment.
- Page 8 FreeWave Technologies 900 MHz High Throughput Installation Guide V10a The Enclosed Transceiver will use FreeWave part number ASC0409DC for serial communication to the Diagnostic port. Model FGR-HT SE Model FGR-HT (Rugged) with ASC2009DC Attached Note: Photos are representative of FGR-HT devices.
Need help?
Do you have a question about the V10a and is the answer not in the manual?
Questions and answers