Connecting To A Tv Only - Philips DVDR75 Owner's Manual

Digital video disc recorder

Hide thumbs Also See for DVDR75:

Service manual (117 pages)

Operating instructions manual (90 pages)

Quick use manual (9 pages)

Table Of Contents

Table of Contents

Connect your Antenna or Cable TV signal to the ANTENNA jack on

the rear of the DVD Recorder.

Connect an S-Video cable (not supplied) to the Recorder's OUT S-

VIDEO (Y-C) jack and to the TV's S-VIDEO In jack.

Connect a supplied two-strand audio cable to the Recorder's

white/red OUT AUDIO L/R (left/right) jacks and to the left/right

AUDIO IN jacks on the TV. The supplied two-strand audio cable has red

and white markings. Match the cable colors to the jack colors.

Connect the supplied RF coaxial cable to the TV jack on the rear of

the DVD Recorder. Connect the other end of the same RF coaxial

cable to the Antenna In jack on your TV. Your TV's Antenna In jack may

be labelled RF In,Antenna In, or 75 ohm. Check your TV's manual for details.

Connect the supplied power cord to the MAINS (AC Power) jack on

the rear of the DVD Recorder.

Connect the power cords of the Recorder and the TV to a power

outlet.

Press STANDBY-ON y y on the front of the Recorder to turn it on.

If "IS TV ON? C03" appears on the display panel, you need to turn on your TV

and set it to the S-Video In channel. (See next step.) This is part of the Initial

Setup of the DVD Recorder.You cannot see the Initial Setup screens until you

turn on the TV and have it on the correct S-Video In channel.

Turn on the TV power. Set the TV to the S-Video In channel. This is

not channel 3 or 4 when you are using S-Video. Your TV remote may have a

button or switch that selects the S-Video In channel. Or, go to your lowest TV

channel and change channels down until you see the DVD background picture

or Initial Setup screen on the TV screen. The Initial Setup screen will appear the

first time you turn on the Recorder. Go to page 18 to continue.