Programming Recording From A Cable Box - Philips DVDR615 User Manual

Timer Recording
{ Repeat }
– Select {Weekly}, {Once} or {Mon-Fri}
(Monday to Friday) recordings and press
OK to confirm.
{ Record mode }
– Select a record mode and press OK to
confirm. See pages 34~35 "Recording
settings - Recording mode").
{ VPS/PDC }
– Select to turn on or off VPS/PDC
mode. For information on VPS/PDC, see
page 39.
G
To clear the timer entries, press the
matching colour coded button on the
remote control to select { Clear all }.
➜
All the settings in the timer menu are
cleared.
G
To cancel the timer programming, press
the matching colour coded button on the
remote control to select { Cancel }.
➜
The timer overview appears.
6
Press the matching colour coded button
on the remote control to select { Store }.
➜
The system will store the timer entry
and return to the timer overview screen.
7
To exit, press TIMER.
8
Insert a DVD+R(W).
9
Press STANDBY-ON to turn off the
DVD recorder.
➜
The DVD recorder must be in standby
mode in order for the timer recording to
occur. If not, a warning message will
appear ten minutes before the recording
starts.
➜
If you ignore the warning message, the
DVD recorder will switch to standby
mode automatically before the
programmed recording begins.
➜
The ' ' icon will light up on the
TIMER
display panel if a timer recording is set.
TIPS: To play a DVD+R on other DVD players, see "Finalising disc (DVD+R)".
During timer recording, press STANDBY-ON will stop recording.
40
1DVDR6xx_Eng05_14134c
(cont'd)
Helpful Hints:
– Set the timer recording one minute ahead
of the programme's start time. This helps
ensure the entire programme is recorded as
the disc requires about 30 seconds to
prepare for recording.
– Programme timer recording from {CAM2}
external input source is not possible.
Programming recording from a
Cable Box
If you have a Cable Box connected to the
DVD recorder's Scart connection
'EXT 2 AUX-I/O' (see page 12), follow
the steps described below to programme
the recordings.
1
Select the channel you want to record at
the Cable Box.
2
Programme the recording with the
required information. Follow the steps
1~9
pages 39~40.
{ Preset }
– Select { EXT2 } as the input channel
and press OK to confirm.
3
Leave the Cable Box on for the
recording.
40
of "Programming Recording" on
9/28/04, 11:20 AM
3139 246 14134