Binary Encoder "Bin Enc"(Lcd); Volume With 11 Click "Cll Knob"; Volume A/D "Vol Knob"(Lcd) - Korg AX3000G Service Manual

BANK_DOWN_R-G 21 BANK_DOWN
BANK_UP_R-G 22 BANK_UP
(Channel)1_R-G 23 (Channel) 1
(Channel)2_R-G 24 (Channel) 2
(Channel)3_R-G 25 (Channel) 3
(Channel)4_R-G 26 (Channel) 4
CONTROL_R-G 27 CONTROL
# REVERB SELECT When turn the knob more than 3-clicks, it will get out of Swith Check and
return to Step 1.
Operation Check 3. Binary Encoder "BIN ENC"(LCD)
1. DRIVE/AMP TYPE Select Knob
Adjust the knob to the top position and rotate the knob in clockwise direction.
Operation Check 4. Volume with 11 Click "CLL KNOB"
1. Turn the knob to MAX(most right).
If the knob is initially MAX, rotate back more than 1 Click then turn it to MAX.
After the Dot of LED start lighting, repeat the decrement.
2. Same as above, on MODULATION SELECT Knob(The initial display is BANK LED "C2"),
3. Same as above, on DELAY SELECT Knob(The initial display is BANK LED "C3"),
4. Same as above, on REVERB SELECT Knob(THe initial display is BANK LED "C4"),
When hold down #AMP/LINE Switch and press WRITE, EXIT/TUNE, it is possible to move the
step.
Operation Check 5. VOLUME A/D "VOL KNOB"(LCD)
1. GAIN: Turn the knobs of AX3000G(or VOLUME:AX300B) to MAX(Most Right) and check that
the DOT of BANK LED can be lighting.
2. Turn it to Minimum(Most Left).