Table of Contents
Advertisement
– Colour settings
You can select one of five predefined sets of colour settings
and one set (Personal) which you can define yourself.
– Personal colour
Allows you to fine-tune the selected colour settings
saturation, brightness and contrast.
– RGB/YUV switching (Video Output)
This setting allows you to toggle the output of the video
signal between RGB(on scart) and Y PrCr PbCb (YUV).
Warning:
When the player is set to Y PrCr PbCb (YUV),
some TV may not properly synchronise with
player on the SCART connector.
– TV System
Allows you to select between PAL, NTSC and AUTO
mode depending on your TV.
Note:
– Refer to "NTSC/PAL Conversion".
Sound
– Digital output
Factory setting: ALL. This means coaxial and optical output
is on. If you are not connecting to equipment with a digital
input, change the setting to OFF.
If your equipment doesn't include a digital multi-channel
decoder, set the digital output to PCM only (Pulse Code
Modulation).
P
14
REPARATION
– Analog output
Select Stereo, Dolby Surround, 3D Sound (TruSurround) or
multichannel output to match your system's playback
capability.
– Night Mode
Optimizes the dynamics of the sound for low volume
playback.
– Speaker settings
Allows you to select speaker settings, volume balance and
delay time and to test the speaker settings.
Speaker settings are only active on the Analog Multi-
Channel Output. (See appendix)
– PCM Output
Allows to select PCM digital output between 48kHz and
96kHz. When 48kHz has been selected, 96kHz (if available
on disc) PCM data stream will be converted to 48kHz.
– Karaoke vocal
Put this setting to ON only when a multi-channel karaoke
DVD is being played. The karaoke channels on the disc will
then be mixed into a normal stereo sound.
Advertisement
Table of Contents
