Table of Contents
Advertisement
Preparation
Connecting to a Digital Audio
Equipment
If your receiver has an Dolby Digital, DTS
or MPEG2 decoder,
1
Connect the COAXIAL or OPTICAL DIGITAL
AUDIO OUT of the DVD player to the
COAXIAL or OPTICAL DIGITAL AUDIO IN on
your receiver.
2
Set the DVD player's digital output to ALL (see
"Personal Preferences")
Notes:
– SACD audio is NOT available on the
Digital audio output (coaxial or optical)
as per the SACD standard.
– If the audio format of the digital output does
not match the capabilities of your receiver, the
receiver will produce a strong, distorted sound or
no sound at all.
– MP3 Audio is not available on the Digital
Output.
REAR
REAR
SPEAKERS
SPEAKERS
RECEIVER with
MPEG 2 or Dolby
Digital™ decoder
TO COAXIAL IN
TO OPTICAL IN
OR
DIGITAL AUDIO OUT
PCM/MPEG2/AC-3/DTS
MAINS
COAXIAL
OPTICAL
S-VIDEO
14
OR
OR
TO S-VIDEO IN
TO VIDEO IN
TO SCART IN
II
TV OUT
I
AUX/VCR IN
VIDEO OUT
Pr/Cr
Pb/Cb
Y
Progressive
Interlace
FRONT
CENTER
SURROUND
1
L
L
L
2
R
R
R
AUDIO
FRONT
SUB WF
SURROUND
CVBS
OUT
Inserting batteries into the
Remote Control
1
Open the battery cover.
2
Insert batteries (AA size) with the correct
polarity as indicated by the + and - symbols
inside the battery compartment.
3
Close the cover.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly
and kept away from children.
Using the Remote Control
G Direct the remote control at the remote sensor
of the DVD/SACD player.
G Do not drop the remote control.
G Do not leave the remote control near extremely
hot or humid places.
G Do not spill water or put anything wet on the
remote control.
+
-
-
+
Hide quick links:
Advertisement
Table of Contents
