Page 2
CONGRATULATIONS ON YOUR SELECTION OF THE FR-1428 (FAMILY RADIO) It is one of the most sophisticated and reliable two way family radios available. BEFORE OPERATING YOUR FR-1428 (FAMILY RADIO) READ THIS MANUAL CAREFULLY...
Page 3
FEATURES our FR-1428 Family Radio is a portable, easy to use, two-way radio that you can carry almost anywhere. It is skillfully constructed to give you reli- able communications for many different applications. The FR-1428 is ideal for use around the house, in your boat, on hunting and camping trips, on the ski slopes or at the mall.
If you wear the handset on your body while using the headset accessory, use only the Audiovox supplied belt clip for this product and ensure that the antenna is at least 1 inch (2.5 centimeters) from your body when transmitting.
Page 6
9. Down Button ( ): Press this button to decrease the volume or channel setting. 10. Built-In Microphone 11. Snap-On Faceplate 12. Speaker Jack: For use with an Audiovox approved headset ac- cessory only. 13. Antenna...
LCD DISPLAY AND OPERATION 1. Scan Indicator: This function allows the user to scan a channel to search for a valid signal. 2. Dual Watch Indicator: Icon appears when dual watch mode is active. Icon disappears when the function is disabled. 3.
7. Receive/Transmit (RX/TX) Indicator: During receive, the left light ning symbol of this icon appears, together with the BUSY indication. During transmission, the right lightning symbol of this icon appears. 8. Busy Indicator: During signal reception or while in the monitor mode, this indication appears on the display, together with the RX lightning indication.
Page 9
our FR-1428 requires four “AAA” cells. Alkaline batteries will provide the best performance from your transceiver. CAUTION: Incorrect battery installation can damage the unit. Never attempt to charge alkaline batteries with the optional battery charger. 1.Lift and rotate belt clip counterclockwise (CCW) to the right to access battery cover.
CHANGING SNAP-ON FACE PLATE (CONTINUED) Pull out the face plate from the body of the transceiver using the groove located at the bottom of the speaker grill. Insert another face plate into the unit and install the two screws in the upper side of the tray in the battery compartment.
Page 11
Changing the Call Ring To select a favorite call ringer melody: 1. Press and hold the CALL button and, at the same time, press and hold the Power button for at least 2 seconds. 2. CA-01 will appear on the display. 3.
Page 12
ever, the same code must also be selected on those transceivers you desire communication. In addition, this feature does not prevent others from listening to your transmissions. FUNCTIONS Channel Scanning Press the Function (F) button three times until the SC icon flashes. Press the Up ( ) button to enable the Scan function in the upward channel direction.
Page 13
VOX Sensitivity Level To set the VOX sensitivity level: 1. With the radio off, press the Function (F) button and, at the same time, press the Power button. 2. LE-03 (or 01-05), or dE-03 (or 01-05) will be displayed. If dE is displayed, press the Function (F) button and LE--- (level) will be displayed.
Page 14
times until the Beep Tone icon ( Then press Up ( ) or Down ( ) to set the function off. Press the PTT button to confirm your selection. When “oF” is selected, no beep tones should be heard. To enable the key tones proceed as before, until Beep Tone icon appears flash- ing.
Page 15
Monitor Function The Monitor (M) button can be used to play all signals present on a channel. This is useful when communicating with other parties at extreme range. The monitor function can be locked on by pressing the Monitor (M) button for two seconds.