Lexus GS430 User Manual page 432

G13073
If the system cannot
vehicle−to−vehicle distance because of a dirty millimeter
wave radar sensor or grille cover while the dynamic radar
cruise control is on, the above message appears.
If this message appears, clean the sensor and grille cover with
a soft cloth and try setting the preset speed again. If the dirt
is removed without cleaning, the system will automatically
enter the "RADAR READY" mode. If the system does not enter
the "RADAR READY" mode even after cleaning or the
message remains on the display, the system might be
malfunctioning. Although it is no problem to continue driving,
contact your Lexus dealer.
easily measure the
STARTING AND DRIVING
G13074
If the system cannot
vehicle−to−vehicle distance because of the following
conditions while the dynamic radar cruise control is on,
the above message appears.
D The driving pattern selector switch is set to the snow
position.
D It is determined that it is difficult to make a measurement
because of bad weather (such as extremely hot weather).
D The wipers are operated at high speed with the wiper lever
in the "AUTO" position.
In the following cases, the dynamic radar cruise control
switches to the "RADAR READY" mode:
D The driving pattern selector switch is changed to the normal
or power position.
D The wipers are stopped or are switched to low speed or
intermittent operation. (Including intermittent and stopped
wipers in the "AUTO" position.)
In the above conditions, press the control lever upward in the
"+ RES" direction and release it. The dynamic radar cruise
control will be restored, however, even after the weather
clears, if the setting operation cannot be performed or if the
warning message still appears, the system might have
malfunctioned. Although it is no problem to continue driving,
contact your Lexus dealer.
easily measure the
411