Copyright 2008 Lloyds Material Supply, Inc. All rights reserved. Duplication without written consent is strictly prohibited. L.M.S. Customer Service Department 1462 East Ninth Street Cal Spas™ and Cal Flame™ are registered trademarks. Pomona, CA 91766. Due to continuous improvement programs, all models, operation, Toll Free: 1-800-CAL-SPAS and/or specifications are subject to change without prior notice.
Safety Instructions Safety Instructions Read this before installing or operating your new Cal Flame fireplace. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. Unless specifically recommended in this manual, do not repair or replace any part of your fireplace.
Page 4
Safety Instructions Storage • Gas sources to the fireplace must be regulated. Do not operate if regulators have been removed. Fire or • When your fireplace is not in use, turn off the gas at explosion can occur. the source. •...
Your Cal Flame fireplace is designed and intended for On LP systems, remove the cylinder from the OUTDOOR USE ONLY in a well ventilated space and fireplace.
Installation and Assembly Liquid Propane (LP) Requirements The 20 lb LP gas supply cylinder used with LP models must be constructed and marked in accordance with the specifications for LP-gas cylinders as required by the U.S. Department of Transportation (DOT) or the CAN/CSA B9, Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods.
Installation and Assembly Check the rating plate to make sure the gas supply Connection you are hooking up to is the gas type the fireplace is Inspect the hose shipped with the unit for damage. Never manufactured for. attempt to use damaged or plugged equipment. See your local LP gas technician for repairs.
Installation and Assembly Fireplace Log Set Placement The log set, log grate and crushed lava rock are shipped together. Remove the log set and un-pack all components. The logs are fragile -- use care when handling. Do not install the log set in an unvented appliance. Once the fireplace is in position, level and safely hooked up to the proper fuel supply, install the log grate over the plate burner.
Operation Operation If you do not follow these instructions exactly, a fire or explosion may result, WARNING: DO NOT use solid fuel, such as causing property damage, personal wood or charcoal, in a gas fueled fireplace. injury, or loss of life. Upon completing the gas line connection, a small amount of air will be in the lines.
Operation Fireplace Lighting Instructions This appliance has a pilot which must be manually lit. To light the burners, turn the gas control that When lighting the pilot, follow these instructions exactly. regulates gas flow to the burners. Turn it from LOW to HIGH to increase the gas flow.
Appendix Appendix Maintenance Replacement Parts Inspect the appliance before initial use. Clean the Call 1-800-CAL-SPAS for any replacement parts not appliance at least annually and have it inspected by a listed below. Be sure to have model name and number qualified field service person.
Flame) – provided that the purchase was made through In the first year only, this warranty extends to the repair an authorized Cal Flame reseller and is subject to the or replacement of warranted parts which are defective following condition and limitations: in material or workmanship provided that the product •...
Page 14
Locating the product serial number The serial number of your Cal Flame fireplace is located on a metal plate on the back of the unit. You will need this number to properly register your product and activate coverage. Write this information in the space provided below.
Need help?
Do you have a question about the FPR 4000 and is the answer not in the manual?
Questions and answers