Inserting Batteries Into The Remote Control; Using The Remote Control; Switching On; Smart Power On/Off - Philips DVD425 Owner's Manual

Inserting batteries into the
Remote Control
1
Open the battery cover by pressing in the tab,
then lift off the cover.
2
Insert batteries with the correct polarity as
indicated by the + and - symbols inside the
battery compartment.
3
Close the cover.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly and
kept away from children.

Using the Remote Control

Direct the remote control at the remote sensor
of the DVD player.
Do not drop or give the remote control a shock.
Do not leave the remote control in extremely
hot or humid places.
Do not spill water or put anything wet on the
remote control.
1
2
3
4
-
+
+
-
Preparation

Switching On

Be sure that the DVD player has been correctly
connected to the TV and audio equipment.
Switch on the TV and DVD player.
Set the TV to the correct Video In channel. (eg.
EXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc.
Please refer to your TV owner's manual for
details.)
The player display lights and the default screen
appears on the TV.
If you are using an external equipment (eg. audio
system or receiver), turn it on and select the
appropriate input source for the DVD player
output. Refer to the equipment owner's manual
for detail.

Smart Power On/Off

When in STOP or NO DISC mode, the DVD
player will switch to standby mode after 15
minutes without any operations for saving energy.
It is easily reactivated by pressing the POWER or
PLAY key on the remote control or the
STANDBY-ON button on the front panel.
11