Step 1: Inserting batteries into
the Remote Control
Open the battery compartment.
Insert two batteries type R06 or AA,
following the indications (+-) inside
Replace the cover.
Using the Remote Control to
operate the Player
Aim the Remote
Control directly at the
remote sensor (iR) on
the front panel of the
Do not put any objects
between the Remote
Control and the DVD
Player while operating
the DVD Player.
– Remove batteries if they are
exhausted or if the Remote Control
will not be used for a long time.
– Do not use old and new or
different types of batteries in
– Batteries contain chemical
substances, so they should be
01-40 DVP640_US5_pt2 (OK)
Make sure you have completed all
the necessary connections. (See
pages 9-10 "Connecting TV").
Turn on the TV and set it to the correct
Video-In channel. You should see the blue
Philips DVD background screen on the
Usually these channels are between the
lowest and highest channels and may be
called FRONT, A/V IN, or VIDEO. See your
TV manual for more details.
Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
Or, the TV Remote Control may have a
button or switch that chooses different
Or, set the TV to channel 3 or 4 if you
are using an RF modulator.
If you are using other external equipment
(audio system or receiver), turn it on and
select the appropriate input source for
the DVD Player. Refer to the equipment
owner's manual for details.
Deactivate Progressive Scan
The progressive scan display presents 60
complete frames per second, rather than
30 frames per second of interlaced
scanning (normal TV system). With nearly
double the number of lines, progressive
scan offers higher picture resolution and
eliminates bothersome motion artifacts
jagged edges on moving objects.
To enjoy the quality offered by
progressive scan, a progressive scan TV is
required. To activate progressive scan,
refer to 'Progressive' on pages 30-31.
Setting up the TV
8239 210 98532
17/03/2004, 5:23 PM