Related Manuals for AR 757
Summary of Contents for AR 757
- Page 1 757 - 767 cod. 90644 - LW...
-
Page 2: Οδηγιεσ Για Την Ασφαλεια
Lire ce manuel avant l’installation/utilisation du nettoyeur en faisant très attention aux INSTRUCTIONS POUR LA SÉCURITÉ Read this manual through carefully before installing/using the cleaner, paying special attention to the SAFETY INSTRUCTIONS Lesen Sie dieses Handbuch vor der Installation und dem Gebrauch des Hochdruckreinigers aufmerksam durch und achten Sie besonders auf die SICHERHEITSANWEISUNGEN Leggere questo manuale prima dell’installazione/uso dell’idropulitrice, prestando particolare attenzione alle ISTRUZIONI PER LA SICUREZZA... - Page 4 CH 17 757 767 Ø13...
- Page 6 1 ÷ 25 m 25 ÷ 50 m Volt 3 x 1,5 mm 3 x 2,5 mm P = O...
-
Page 7: Safety Instructions
English SAFETY INSTRUCTIONS SAFETY “MUSTS” 2.2.1 . all electrical conductors MuSt Be the appliance you have purchased is a technologically advanced hort circuit hazard PrOtecteD against the water jet. product designed by one of the leading european manufacturers of high pressure pumps. to obtain the best performance from 2.2.2 . - Page 8 English B2 Lance B6 Detergent tank GENERAL INFORMATION (FIG.1)/PAGE 3 B3 Gun with safety catch (on models with this feature) Use of the manual B4 Power supply cable with plug (on models with this feature) this manual forms an integral part of the appliance and should be 4.4.1 Accessories (if included in the supply package –...
- Page 9 English 3) Set the starter device on (ON/1). ADJUSTMENT INFORMATION (FIG.3)/PAGE 5 Storage Adjusting the spray nozzle (for models with this feature) 1) Switch the appliance off (OFF/0). Water flow is adjusted by regulating the nozzle (E). 2) remove the plug from the socket. Adjusting the detergent (on models with this feature) 3) turn off the water supply tap.
-
Page 10: Troubleshooting
English TROUBLESHOOTING Problem Possible causes Remedy Nozzle worn replace nozzle Water filter fouled clean filter (L) (fig.5) Water supply pressure low turn on water supply tap fully air being sucked into system check tightness of hose fittings Pump does not reach working Switch off the appliance and keep depressing and releas- pressure ing the gun trigger until the water comes out in a steady... - Page 11 55014-2; EN 61000-3-2; EN 61000-3-3; EN 61000-3-11; EN 60704-1 Name and address of the person in charge to give the technical file: Motor insulation class F class F Stefano Reverberi / AR Managing Director Motor Protection iPX5 iPX5 Via M. L. King, 3 - 41122 Modena, Italy...
- Page 12 ✍...
- Page 13 ✍...
- Page 14 annovi reverberi S.p.a. Via M.L. King 3 41122 Modena (italy) www.annovireverberi.it...
Need help?
Do you have a question about the 757 and is the answer not in the manual?
Questions and answers