Mitsubishi Electric MSZ-LN25VGW Operating Instructions Manual page 7

I
-SEE OPERATION
In the i-see control mode, the room temperature is controlled based on the
sensible temperature.
1
Press during COOL, DRY, HEAT and AUTO mode
to activate the i-see control mode.
• Press gently using a thin instrument.
• lights. (Operation display section)
• The default setting is "active".
2 2
Press several times to cancel the i-see control
mode.
Note:
Any person at the following places cannot be detected:
• Along the wall on which the air conditioner is installed
• Directly under the air conditioner
• Where any obstacle, such as furniture, is between the person and the air
conditioner
A person may not be detected in the following situations:
• Room temperature is high.
• A person wears heavy clothes and his/her skin is not exposed.
• A heating element of which temperature changes significantly is present.
• Some heat sources, such as a small child or pet, may not be sensed.
• A heat source and the air conditioner are more than 6 m apart.
• A heat source does not move for a long time.
Do not touch the i-see sensor. This may cause malfunction of the i-see sensor.
The intermittent operating sound is a normal sound produced when the i-see
sensor is moving from side to side.
Refer to page 9 "Absence Detection" for
Cancel
and .
En-6