Advertisement
Available languages
Available languages
17.
Do not abuse the power cord
-Be sure your cable/extension cable is properly wired and in good condition.
Always replace a damaged cable/ extension cable or have it repaired by
aqualified person before using it. Never yank or pull the cable to disconnect
it from the power socket. Never carry your power tool by it's cable. Keep the
cable away from amp, heat, oil , solvents, and sharp edges.
18.
Check for damaged or missing parts
-Before each use check if any part of the power tool is damaged or missing,
check carefully that it will operate properly and perform its intended function.
Check alignment of moving parts for binding. Any guard or other part that is
damaged should be correctly repaired or replaced. Do not use if the power
switch does not turn the power on and off. Check any other condition that
may affect the safety of the power tool.
DO NOT USE IF DEFECTIVE
1.
Direction of feed
-Feed work into a blade or cutter against the direction of rotation of the blade
or cutter only.
2.
Don't leave the tool running unatended
-Always wait until your power tool has come to complete stop before leaving
it and then disconnect from power source.
ADDITIONNAL SAFTY INSTRUCTIONS FOR PRESSURE WASHERS
1.
Never direct the water jet at people or animals, as the water pressure is very
powerful and can cause serious injury. Avoid aiming the jet at the pressure
washer body or the power supply.
2.
Do not use in an area where ventilation could be limited and NEVER cover the
unit while it is in use.
3.
Always ensure the water supply as connected and the flow is continuous into
the washer when being operated. If the washer is operated when dry, it could
cause irreparable damage to the machine.
4.
Please ensure that you engage the trigger safety catch in the safe position
when spraying has stopped, even if this is for a short period of time.
5.
After use, the machine should be drained of all water to reduce the risk of corrosion.
6.
When not in use, the machine should be stored in a dry location that will not
fall below freezing point.
7.
Do not operate the washer when it is raining or during a thunderstorm.
8.
Always wear safety glasses or goggles and waterproof protective clothing
when operating the washer.
9.
ALWAYS use this sequence to prepare the product for storage:
- Switch off and disconnect the mains electrical power to the machine.
- Switch off the water supply to the machine.
- Discharge any remaining water in the lance by pulling the lance trigger.
- Disconnect the machine from the water supply NEVER turn the water supply
off BEFORE switching off the pump motor to prevent the pump running dry,
as this will cause irreparable damage to the machine NEVER disconnect the
high-pressure discharge hose from the machine while the system is still pressurised.
Always follow the above procedure.
17
Advertisement
