Panasonic HDC-SDT750PP Service Manual page 18

7
(After checking the operation description, touch [NEXT].)
To adjust the vertical position, rotate the vertical position
adjustment dial so that the black horizontal line at the right of the
screen is in the center of the red guidelines
Touch [NEXT].
8
Removing the lens front cap.
Touch [NEXT].
9
(After checking the operation description, touch [NEXT].)
Adjust the vertical alignment adjustment dial
position of the subject shown duplicated.
Aim the unit at a subject from a distance of approximately 1.2 m (3.9 feet) to 2 m (6.6 feet),
and keep the image shown level by using the guidelines
Difference in horizontal direction is characteristic of 3D video.
It is recommended to stabilize the unit using the lens front cap as a platform when
performing the adjustment.
Touch [COMPLETE].
10
Touch [EXIT] to end the adjustment.
After adjustment, a single screen appears.
When re-attaching the 3D Conversion Lens or after
an impact etc., it is recommended that you perform
the adjustment again.
11
Press the recording start/stop button to start recording.
When the 3D Conversion Lens is attached, the zoom position is fixed, and the zoom
operation is disabled.
When recording in 3D, the image will appear with black frame around it. The black frame
will be recorded in the video.
To ensure that the 3D video can be safely viewed, pay attention to the following
points when recording.
Where possible, record with the unit in a horizontal state.
Do not get too close to the subject. (record from a distance of at least 1.2 m (3.9 feet).)
When moving the unit as you record, move it slowly.
Try to hold the unit as steady as possible when recording while riding in a vehicle or
walking.
.
to align the vertical
7/8
.
0h00m00s 0h00m00s
3D
R 1h20m R 1h20m
appears.
3D
18
7/8