•
Insert a 3/8"-drive ratchet wrench (set to loosen)
into the square hole found in the idler bracket on
the left side of the deck's surface. See Figure 26.
Idler Bracket
Figure 26
•
Grasp the ratchet's handle and pivot it toward the
front of the tractor to relieve tension on the belt.
Belt Guard
3/8" Square
Hole
Left Hand
Spindle Pulley
Idler Pulleys
•
With belt tension relieved, carefully remove the
belt from around the left-hand spindle pulley.
Carefully allow the ratchet to pivot
IMPORTANT:
rearward before removing it from the square hole.
46" Deck
•
Grasp the rearmost portion of the PTO idler bracket
and pivot it toward the discharge chute to relieve
tension on the PTO belt.
•
Remove the PTO belt from around the engine
pulley and the PTO idler pulley(s).
•
Grasp the deck idler pulley and pivot it toward the
left side of the deck to relieve tension on the deck
belt.
All Models
•
Remove the deck belt from around all pulleys,
including the deck idler pulley(s).
•
Route the new belt(s) (deck belt first - 46" deck)
as shown in Figure 27 and Figure 28.
•
Remount the belt guards removed earlier.
Engine Pulley
Figure 27
25
42-inch Decks
Right Hand
Spindle Pulley